PUD No 1 of Grays Harbor County (WA) Outage & Grid Reliability
PUD No 1 of Grays Harbor County (U.S. EIA Utility #7548, Political Subdivision) serves 45,827 total customers across 5 county/counties in Washington (BPAT grid). In official 2025 U.S. EIA Form 861 filings, customers experienced an average of 1036 outage minutes per year (17.3 hours, SAIDI with major events) across 2.8 interruptions/yr — earning an EP Utility Reliability Grade of B. Observed average residential rate: 12.69¢/kWh.
What PUD No 1 of Grays Harbor County Outage Data Means for Customers
PUD No 1 of Grays Harbor County is a political subdivision buying through the BPAT balancing authority, and it serves 45,827 customers: 40,116 residential, 5,692 commercial and 19 industrial. Lines run across Grays Harbor, Jefferson, Lewis, Pacific and Thurston counties.
The 2025 EIA Form 861 numbers say the average customer sat in the dark about 1036 minutes, or roughly 17 hours, with major events included. The average customer also saw 2.8 outages. Take out the major events and the figure drops to 338 minutes, about 5.6 hours. That gap tells you most of the pain comes from big storms, not routine trouble. The EP grade is B, in a high outage duration band of 12 to 20 hours a year.
Those are system averages. A customer at the end of a long rural feeder through timber will usually do worse than a customer near a substation, so plan for your own line.
Sizing Quiet Home Backup vs. Standby Power in WA
Start with a list of what you need running: refrigerator, a few lights, internet, phone charging, any medical equipment, and the furnace blower or a small heater. Add up running watts, then check starting watts for anything with a motor, like a well pump or a heat pump compressor.
A battery system covers the routine outage well. It is silent, needs no fuel run, and handles an afternoon without power easily. The 338-minute figure is the kind of outage a battery is built for. The 1036-minute figure, driven by storms, is where a battery sized for essentials can run dry, especially if the sun is hidden for days.
If you are out past the pavement, on a well, or depend on medical gear, a permanently installed standby generator on propane or natural gas is the sensible partner to a battery. The residential rate of 12.69 cents per kWh is modest, so backup power will not save you money. You are buying continuity, and generator fuel will cost more per kWh than the grid.
Whatever you choose, have a licensed electrician install a transfer switch or interlock under permit. Never backfeed through a dryer outlet, because that puts lineworkers at risk. Run the generator under load on a schedule and keep fuel fresh. Follow the manufacturer's clearance rules for exhaust and U.S. EPA-compliant equipment labels.
What Local Shops, Clinics & Facilities on PUD No 1 of Grays Harbor County Lines Should Do
Decide what must stay on and what can wait. For a shop, that is usually the point-of-sale system, refrigeration, lighting and the network closet. For a clinic, it is medication and vaccine refrigeration, essential medical equipment, and communications. For municipal operators, it is pump stations, lift stations, radios and the office that dispatches crews.
Separate those loads onto a dedicated critical panel so a generator or battery is not asked to carry the whole building. Use an automatic transfer switch where an outage cannot be tolerated, and test it under real load, not just by starting the engine.
Plan fuel for a long storm event, not a short one. Know who delivers, and what you do if roads are blocked. Keep a written restart checklist and a contact sheet, and tell your PUD account representative what your critical loads are. The 19 industrial customers and larger commercial accounts should ask about their feeder's outage history before sizing anything.
1. Official U.S. EIA Form 861 Reliability & Customer Record
| EIA Form 861 Metric | Observed Utility Value | Reporting Basis |
|---|---|---|
| SAIDI (Total Outage Minutes / Year) | 1036 min/yr (17.3 hrs) | All Events w/ Major Event Days (2025) |
| SAIFI (Average Outages / Year) | 2.8 interruptions/yr | IEEE / Utility Standard w/ MED |
| CAIDI (Avg Restoration Minutes / Outage) | 370 min/outage | Average Customer Outage Duration |
| SAIDI (Blue-Sky / Excluding Major Storms) | 338 min/yr | Without Major Event Days |
| Total Customers (Res / Com / Ind) | 45,827 (40,116 / 5,692 / 19) | 2025 EIA Form 861 |
| Observed Residential Electricity Rate | 12.69¢/kWh | 2025 EIA Revenues / MWh |
| Ownership & Balancing Authority | Political Subdivision • BPAT | U.S. EIA Form 861 |
2. Counties Served by PUD No 1 of Grays Harbor County (5 Tracked in Washington)
Select your county below to view local FEMA disaster history, CMS 24/7 emergency hospitals, NOAA Weather Radio frequencies, and county Continuity Grades:
3. Frequently Asked Questions (PUD No 1 of Grays Harbor County)
How reliable is PUD No 1 of Grays Harbor County compared to other US utilities?
Under 2025 U.S. EIA Form 861 reporting, PUD No 1 of Grays Harbor County logged 1036 total outage minutes/year (SAIDI with Major Event Days) and 338 minutes/year excluding major storms (High Outage Duration Territory (12–20 hrs/yr)).
What counties does PUD No 1 of Grays Harbor County serve in Washington?
U.S. EIA Form 861 Service Territory records map PUD No 1 of Grays Harbor County to Grays Harbor County, Jefferson County, Lewis County, Pacific County, Thurston County in Washington.
What backup battery or generator size is recommended for PUD No 1 of Grays Harbor County customers?
For outages lasting multi-day stretches during storms, homeowners should start with 7–14 kWh of quiet indoor LFP battery backup for refrigeration, Wi-Fi, and medical devices—or an 18–22 kW standby generator with a UL 1008 transfer switch for full HVAC/well loads.